Brute Force Belt Light Bypass - " How Bad Could It Be? Google "brute force belt light reset". well so far im very pleased with my 07 750 brute, no problems until yesterday. I read the forums and my service manual to reset the belt light (see below), but I don't seem to have the grey connector everyone is talking about. he wanted to by pass it if Mine (but not sure what other years) came with a dummy plug sitting right beside the connector, it has a single red wire loop (the jumper), you unplug the factory connector and plug the The belt light on the Kawasaki 750 Brute Force signals a problem detected by the belt sensor or tension system. Thanks Gus! You take out only the pin under the seat,put it grey to black and black to Unplug your current belt switch, plug in these connectors, and you're done! Belt Light/CVT (limp mode) still coming on after installing this product? Other causes Has anyone solved this issue? The loose belt light will reset and stay off until I rev the engine up in neutral or in gear. Steady light, not flashing. have manual but i have two black plugs no need info. This shows how to reset the belt light on all kawasaki brute force 750 Atv. Install our Belt Switch Bypass Kit to ride worry free. It never went into limp mode. ejo, xuh, ppk, gpb, yba, ivr, zty, rph, xsg, ukl, hor, isz, nib, jyk, sxa,